Image BBS v3.0: CMD HD Setup

Dec 13, 2020 | BBS, Image BBS, Software, Workbench | 3 | 3,857

This is the setup tutorial video by X-Tec for Image BBS v3.0 using the CMD HD. In this video X-Tec will go from the initial install all the way through to getting your Image v3.0 BBS online and accepting calls using the CMD HD in VICE. X-Tec is one of the original developers of Image BBS 3.0 who has continued to work on the Image BBS software over the years along with Bucko and a handful of others.

Make sure you have downloaded Image BBS v3.0 available from our DOWNLOADS

Share the love

Comments and replies

Your email address will not be published. Required fields are marked *

Email notifications of this thread

3 Comments

oldest

newest most voted

Inline Feedbacks

View all comments

Michael Hasson (RED DEVIL)

December 15, 2020 5:54 am

OMG I cannot believe Image BBS 3.0 was released I use to have ver.1.2 and at that time Fred Dart was talking about Image 2.0 and that was the end of that.. I Ran The Ram’s Den with my Dad I ran it for 2 years after my father got sick I decided to shut the board down, I also purchased a 40 meg Lt.Kernal for 800.00….. So since all my fathers commodore equipment got damaged in Hurricane Floyd I just never tryed to repurchase it,untill now…Thank you all for keeping the 1 thing I loved to do growing up… Read more »

Mike Newkirk

Member

June 18, 2021 12:52 pm

anyone using a commodore wifi modem with this? My system locks up (stuck between lines 60335-60345) after blocks free check. I never can make it to instant logon step. Status shows that I am in the sub.modem part of the system.